Hey guys, zakk Wylde here. Welcome to another episode of skate school. In today's episode we're going to teach you how to easily and affordably clean your air. So grab the board. Let's get started. In this episode we're going to show you how to easily and affordably clean your bearings.

Make sure you have your bearings spacers and the bolts to your trucks already laid out on the tape. Make sure it's a flat clean surface that's okay getting a little dirty. Head to the store and find some wd 40 You can find a small can this size for about $3 at the store. This will last you several bearing cleaners. Next, find an empty soda can cut about a fourth of the way down on the can. So there's just a little left on the bottom.

Make sure to shake up the WD 40 before you use it. Start by spraying the WD 40 into the bottom of the soda can spray enough in there until there's enough to immerse your bearings underneath the liquid. You wanted to fully cover the bearings, you can go ahead and spray wd 40 on top of all your bolts and bearings before you put them into the can drop them all into the can and let them soak for about 15 minutes. Only drop all of your bearings into the can. Once your bearings are done soaking in the WD 40 it's time to take them out and clean them with the paper towel. I would recommend that you wear gloves and a face mask when you do this to be the safest bet you can.

You don't want to get any of these chemicals in your mouth, nose, eyes, or under your nails. Use the heavy duty paper towel to clean off all the bearings and all the bolts and stuff Wipe them into all the dirt and sand is clean out of your bearings. After you've wiped off all your bearings, you can pop them back in your wheels and get this game. Thanks for watching guys. Don't forget to SUBSCRIBE, like, comment and share with your friends. Let us know what you want to see next on space.